HAIR BODY 577 Based on the above, it can again be concluded that current cosmetic prod- uets do not increase hair body significantly by increasing the diameter of the fibers. Even in the ease of setting gels, the effectiveness is not due primarily to this parameter. Fiber configuration and array represent an area through which hair body is often increased. The higher the curl level and the greater the disorientation of the fibers, the greater will be the bulkiness and, thereby, the body. Perma- nent waving solutions and setting lotions and gels operate by this mechanism. All wet hair treatments can operate through this method, as they provide the opportunity for obtaining a temporary water set in the desired configura- tion. Prior chemical treatments, such as bleaching or waving, which increase the fiber swelling in water improve the water settability further and, therefore, increase the temporary body characteristics. For the sake of completeness, it must be mentioned that some hair care appliances (i.e., curling devices and even hand-held driers) belong to this category. Hand-held driers, in the nor- mal mode of operation, provide water set to the hair at a high angle relative to the skin and reduce the level of eonfigurational conformation among neigh- boring fibers. The factor through which cosmetic products most often influence hair body is the fiber-fiber interaction. No cosmetic treatment leaves the fiber surface unmodified relative to its starting condition. The products which most drastically increase hair body by this mechanism are sprays and polymerie setting lotions. These form rigid joints between con- tacting fibers which are similar to welding in steel structures. In order to over- come the segmental stabilization of involved fibers, the joints must be broken. Even when this is achieved, subsequent fiber displacement is still resisted as long as laterally extending asperities of the broken joints remain on the fibers. Therefore, the structural strength of a sprayed hair mass decreases with comb-out, but does not sink back to its original presprayed level until the residues are fully removed, for instance, by shampooing. The opposite ease-a lowering of body-can be accomplished by surface coating when the deposit is a lubricant with low static frictional eoeffleient. Quaternary ammonium components behave this way. The shear strength of fiber joints is very low in this ease, therefore, the fibers will displace, even under very low external forces and occupy lower-energy positions. With this treatment alone, a bulky high-bodied structure cannot be achieved when all other parameters are equal. Other surface deposited materials can achieve intermediate positions between these extremes. Generalizations, according to conventional classifica- tion of materials, must be avoided. Oil, grease, and wax-type components of shampoos, rinses, and conditioners, which are lubricants in the everyday use of the word, can increase hair body. They form adhesive joints between con- tacting fibers with finite well measurable strength. The bonding strength de-
578 JOURNAL OF THE SOCIETY OF COSMETIC CHEMISTS rives both from surface tension and from static shear rigidity of the thin films. The kinetic frictional resistance of these ioints is often low, allowing easy combing, but their static strength is considerable-in the range of a few milli- grams. The layer thickness, especially for long hair, must be controlled be- cause, in the case of overloading, the hair mass may compact and settle under its own weight. Chemically active hair cosmetics-bleaches, permanent waves and oxidative dyes-increase the material frictional coefficient and the surface roughness of the fibers and thereby reinforce the fiber-fiber interactions. This results in increased body. III. CONCLUSIONS It is possible to assign physical interpretation to a cosmetic term such as hair body which is 1.ogical and self-consistent in scientific meaning and corre- lates with the linguistic use pattern of the word. Furthermore, it is possible to break down the complex body characteristics into fundamental, single parameter, physical factors. The body attributes of hair cosmetics can be studied systematically, by evaluating their effects on these fundamental fac- tors. It is, of course, quite easy to design measurements for directly assessing the influence of cosmetics on the complex phenomena, and we have used such techniques for body determination for some years. Obviously, the present discussion represents a single viewpoint and further discussions by individuals from different areas of the fiber and cosmetic fields would be highly desirable to achieve a consensus on, and a better definition of, these rather important terms. ( Received Junc 3, 1975 )
Previous Page